Continuous Spouting offers a wide range of coloured steel or copper downpipes to suit a variety of applications to compliment your spouting or contrast with your colour scheme. Round downpipes are available in various sizes, and materials to suit any style of home, building or factory. Sizes range from a small drainage requirement up to larger factory requirements. The coloured steel downpipes are available in the same colours as the spouting (they actually use the same Zincalume ® coil as the spouting), with bends and clips all colour matched.
For every 10 square metres of actual roof area drained, 700 square millimetres of downpipe is required. This calculation is based upon the assumption that the maximum rainfall does not exceed 125mm per hour.
It is considered the best practice to drain to different points, using smaller downpipes rather that one large outlet. Where possible, downpipes should be spaced at not more than 12 metres apart.
handmade bends
pre-formed cast bends
3 sizes of downpipes
Downpipe & Clip
Downpipe & Munzing Ring
Munzing ring - brass, copper, aluminium
Downpipe Bend
Downpipe Bend
All of our bends are uniquely designed with male and female ends, so as to allow the most efficient flow of water. A typical bend is at 95 degrees but can be hand made to differing angles if required.
Downpipes
